Removing Sediment in Your Santa Rosa Water Heater

Posted by on Dec 13, 2013 in Water Heater Repair Santa Rosa CA | 0 comments

If you have a problem with sediment, you’re most likely already knowledgeable about it. Gas fired water heaters in certain commonly show that there is a sediment problem with rumbling noises each time the tank cycles, while still keeping great water temperature. Thankfully, sediment in your hot water tank can easily be eliminated, maintaining the functionality of your heater.

Water Heater Repair Santa Rosa CA

Water heater (Photo credit: km6xo)

If you have a gas water heater, turn the control to pilot. If you have an electric design, you need to shut off the power at the panel. Next shut off the water above the heater so no brand-new water can get in the tank. Then attach a hose to the drain valve. The other end of the hose ought to preferably go to a floor drain, although a pail can also be utilized.

Open the drain valve to get rid of all the water from the tank. The majority of the sediment must be gotten rid of by this easy act. Keep the drain valve open, but switch on the water also, enabling some to get in the tank. Turn off the water after a couple of minutes. Repeat this a number of times to coax as much sediment out with the water.

As a final measure, close the drain and fill the tank a minimum of half full. Then you can drain it for a final time to get rid of any last remains of sediment. To prevent additional typical sediment problems, you can install a sediment filter for your tank if your trouble is mainly with sand. A sand filter need to be installed on the cold trunk line.

Occasionally sediment can likewise congest the drain valve itself. Ideally you should be able to wash the valve out under high pressure, however often the valve has to be replaced after a cleaning. You can achieve this job while the tank is still complete, simply shut off the gas or electrical power and await the water in the tank to cool. You ought to likewise not use any water in your residence will completing the replacement.

To eliminate the drain valve, simply make use of a huge groove joint pair of pliers to turn off the old valve. Then set up a replacement valve by turning it in clockwise. Make sure to use pipe thread sealing tape or pipe joint substance on the threads to make sure that the connection will hold water.

If you are preparing to remove the drain valve, you could consider before installing the replacement valve providing your tank a last flush. This is best done if you have a floor drain that will quickly drain the water and sediment.

Lots of people erroneously think that a sediment filled tank or a dripping drain valve is cause to change the whole hot water heater. By these easy maintenance actions, many residents must be able to take care of any problems by themselves. Obviously, if you run into various other problems while completing this repair, call a plumbing professional who will have the ability to easily resolve the problem.

Water Heater Repair Santa Rosa CA invites you to read more from us:
Enhanced by Zemanta